Does your tower have a thrust bearing? If yes is it cold where you are?
Could be old/dirty/cold grease in the bearing. I chased down a rotor "low
voltage" rotor problem once and it turned out my bearing was so grungy it
was binding up. Remove the grease fitting, squirting solvent in it, picking
out muck, then squirting new grease fixing the "low voltage" problem! Just a
thought....
73
Dan
K0DAN
-----Original Message-----
From: Doug Snowden
Sent: January 12, 2013 06:20 PM
To: towertalk@contesting.com
Subject: [TowerTalk] HamIV Rotor sluggish
The rotor is on a tower and the run is about 275 ft from the shack.
What is the best way to get more response from it? At times I have to
rock the antenaa back and forth to get it to even move. I am sure it
must be voltage loss. Boost the voltage from the controller?
Doug, N4IJ
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|