Towertalk
[Top] [All Lists]

Re: [TowerTalk] grounding elevated vertical for lightning?

To: "Jim Lux" <jimlux@earthlink.net>, <towertalk@contesting.com>
Subject: Re: [TowerTalk] grounding elevated vertical for lightning?
From: "Jeff Blaine" <keepwalking188@yahoo.com>
Date: Fri, 8 Feb 2013 16:28:56 -0600
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
Spark gap it is, then...  Thanks for all the suggestions.

73/jeff/ac0c
www.ac0c.com
alpha-charlie-zero-charlie

-----Original Message----- From: Jim Lux
Sent: Friday, February 08, 2013 3:37 PM
To: towertalk@contesting.com
Subject: Re: [TowerTalk] grounding elevated vertical for lightning?

On 2/8/13 10:36 AM, Jim Brown wrote:
On 2/8/2013 5:52 AM, K1TTT wrote:
What is the best way to ground this antenna?  Can I put a few ground
rods at
the center base and run them up to the radial junction?

NO! The work of Rudy Severns, N6LF, on the topic of elevated radials
shows that elevated radials should NOT be grounded, because doing so
causes radial currents to be unbalanced, which increases loss.  For the
same reason, a common mode choke must be used on the coax at the feedpoint.

Exactly... this was one of the interesting non-intuitive findings when
NEC3 and NEC4 were being validated: antenna performance with radials
alone was better than with the ground rod added.


I assume you want to ground for lightning protection?  Then a spark gap
is your friend. Open circuit for RF, but when lightning strikes, it
closes.  Hook the spark gap to your ground rods and to your antenna, and
you're all set.  A 1/10" gap breaks down at 7kV. Needle gap is more like
2kV.




_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>