dualband 80/160
73/jeff/ac0c
www.ac0c.com
alpha-charlie-zero-charlie
-----Original Message-----
From: R.Morris
Sent: Saturday, February 09, 2013 10:49 PM
To: towertalk@contesting.com
Subject: Re: [TowerTalk] grounding elevated vertical for lightning?
On 02/09/2013 07:34 PM, Jeff Blaine wrote:
Static bleed is not an issue here, sort of. The antenna is grounded
through the antenna switch which has a 50 ohm load on the line when
it's not selected (unless that's been zapped). And when the line is
selected, it's run through a W3NQN type filter so it's got a pair of
coils running to ground on the shack side.
In lieu of the RFC, I could use some high-value resistors at the
feedpoint.
If it's single band, a shorted, 1/4 wave stub, grounded ?
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|