On 2/19/2013 2:38 PM, Jim Brown wrote:
On 2/19/2013 9:28 AM, Roger D Johnson wrote:
s not the loss on receive determined by the RX input impedance? IOW
It's the LOAD on
the transmission line.
Yes, BUT -- signal to noise on receive on the MF and HF bands is nearly
always determined by band noise (that is, noise picked up on the
antenna), not circuit noise in the RX. VHF/UHF is a very different
story -- circuit noise CAN be the limiting factor for hams living in
quiet locations, and in those situations, line loss on RX does matter.
Also, the input impedance of most receivers is not well controlled, and
often differs significantly from its nominal value.
A good rule of thumb is that if the band noise increases by 3dB or more
when you connect the antenna, your RX system is mostly limited by noise
picked up on the antenna, and for a 6dB increase is entirely limited by
external noise. in those quiet locations where circuit noise is the
limiting factor, we usually want an RX preamp up on the tower.
Does such a place exist on 160, 75, and 40?..Except when the bands are dead.
73
Roger (K8RI)
73, Jim K9YC
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|