Towertalk
[Top] [All Lists]

Re: [TowerTalk] us tower hdx-689 sheave replacement

To: towertalk reflector <towertalk@contesting.com>
Subject: Re: [TowerTalk] us tower hdx-689 sheave replacement
From: Bob K6UJ <k6uj@pacbell.net>
Date: Wed, 13 Mar 2013 18:43:18 -0700
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
How do you guys tell if the bearing is frozen ?  Can you tell by inspection ?  
Maybe
while the tower is being raised or lowered by looking at the side of the 
bearing ? (if you can see it)
I want to check all of mine and trying to figure out how to go about it.

Bob
K6UJ



On Mar 13, 2013, at 6:03 PM, Jim Thomson wrote:

> Date: Tue, 12 Mar 2013 14:00:41 -0700
> From: "Rick Karlquist" <richard@karlquist.com>
> To: "Rich Hallman - N7TR" <rich@n7tr.com>
> Cc: Bob K6UJ <k6uj@pacbell.net>, towertalk reflector
> <towertalk@contesting.com>
> Subject: Re: [TowerTalk] us tower hdx-689 sheave replacement
> 
> Rich Hallman - N7TR wrote:
>> Just spoke with us towers and I have two 5 inch sheaves on the way. $135
>> each.....
>> 
>> The old pulley is fine...just the bearing is locked. Ray N6VR sent me a
>> link on replacement bearings on eBay...so ill check that out and see what
> 
> Have you tried squirting it with WD-40 or a similar elixir to see
> if you can free it up? Worked for me. After the WD-40, I applied
> regular oil to it.
> 
> Rick N6RK
> 
> ##  The other stuff that will work is called... PB Blaster.
> 
> Jim  VE7RF
> 
> _______________________________________________
> 
> 
> 
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>