Hi Jake,
Actually the power poles will be very easy to setup for polarity. Much
easier to setup compared to cinch's or utility trailer connectors. I
can have them crimped up by the time I had my soldering iron ready to go.
Rich - N5ZC
On 7/6/2013 11:40 AM, jcjacobsen@q.com wrote:
A snippet from Rich:
< I plan on using a group of Anderson Power Poles for a quick disconnect
for my rotor cables. >
Rich,
While that sounds like a good idea, I'd like to suggest either a multi-pin Cinch-Jones
connector or a connector for a utility trailer. The Pwr-Poles will be hard to keep
"straight" as far as 1-1, 2-2, etc. With the others, it's one plug-up. they are
polorized, and you're done.
K9WN Jake
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|