Towertalk
[Top] [All Lists]

Re: [TowerTalk] HAM IV Height

To: James Setzler <jms_k1sd@verizon.net>, Towertalk Reflector <towertalk@contesting.com>
Subject: Re: [TowerTalk] HAM IV Height
From: k6ye@q.com
Date: Fri, 20 Sep 2013 00:44:49 -0400 (EDT)
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
Jim,

I replaced a T2X Tailtwister with a Yaesu G-2800DXA and other than rewiring the 
plug on each end, I had to change nothing at all. The fit was perfect. I do use 
a thrust bearing to carry all of the weight of a Force-12 C-4XLD on a Hy-Gain 
HG-54HD crank-up tower.

Good luck in your endeavor.

Semper Fi,

Tommy - K6YE
DX IS and CW RULES


----- Original Message -----
From: James Setzler <jms_k1sd@verizon.net>
To: towertalk@contesting.com
Sent: Thu, 19 Sep 2013 11:35:16 -0400 (EDT)
Subject: [TowerTalk] HAM IV Height

Greetings,

 

I'm replacing a HAM IV with a Yaesu G-800GXA and concerned about the depth
of the mast into the rotor housing.

 

What is the dimension on the HAM IV from the mounting plate to the point
that the bottom of the mast rests?

 

    73 James K1SD

 

 

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>