Has anyone in this group tried three quarter inch type NM non-metallic
liquid-tight conduit to protect the RG-213 rotor loop from abrasion when the
RG-213 is tied to one leg of the tower and then wound around the mast so as to
tighten or untighten one half turn of the two turns laid on the tower bearing
plate? Three quarter inch liquid-tight conduit easily allows the RG-213 with
PL-259 to pass making future replacement of the liquid-tight conduit if
necessary, easy. I’m getting ready to try liquid-tight conduit as protection of
the rotor loop and appreciate any observations or comments.
73 ES DX,
Gary -- AB9M
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|