| To: | "towertalk" <towertalk@contesting.com> |
|---|---|
| Subject: | [TowerTalk] Wiring Sky Needle tower for 220 VAC |
| From: | "Wilson" <infomet@embarqmail.com> |
| Reply-to: | Wilson <infomet@embarqmail.com> |
| Date: | Tue, 5 Nov 2013 17:01:57 -0500 |
| List-post: | <towertalk@contesting.com">mailto:towertalk@contesting.com> |
I’m not sure of this, but the motor must be a seriously lagging current load. I wonder if some power factor correcting caps would get the sluggish motor going. With the lagging PF, you get the most drop when the supply voltage is already going pretty low... With correction, the caps would handle some of the load. WL _______________________________________________ _______________________________________________ TowerTalk mailing list TowerTalk@contesting.com http://lists.contesting.com/mailman/listinfo/towertalk |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TowerTalk] Cadweld One Shot Source, Larry |
|---|---|
| Next by Date: | Re: [TowerTalk] Cadweld One Shot Source, Roger (K8RI) on TT |
| Previous by Thread: | [TowerTalk] FW: Wiring Sky Needle tower for 220 VAC, Matt |
| Next by Thread: | Re: [TowerTalk] Wiring Sky Needle tower for 220 VAC, Mike Fahmie |
| Indexes: | [Date] [Thread] [Top] [All Lists] |