The best commercial penetrating oil is PB Blaster and even better but with a
limited shelf life is to mix acetone and transmission fluid. Keep it away
from painted surfaces though
Mark N1UK
----- Original Message -----
From: "Roger (K8RI) on TT" <K8RI-on-TowerTalk@tm.net>
To: <towertalk@contesting.com>
Sent: Monday, 09 December, 2013 2:36 PM
Subject: Re: [TowerTalk] Pentrox
On 12/9/2013 9:30 AM, Frosty wrote:
Is there anything that will dissolve this junk. I don't understand why
people think that they have to put
Pentrox or Nolox on beam elements. It just freezes them up so that they
will not come apart.
I have taken elements apart after years of use and the NoAlox was still
greasy. Given that some of it had washed out, but I've had no problems
with it.
I didn't know that Pentrox hardened, but I've only used it on threads
73
Roger (K8RI)
Charles F. Frost
Frosty K5LBU
frosty1@pdq.net
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|