Check to see that the offset value is correct. Use the GH config program.
(You can do it from the front panel but I forget how.) I suspect somehow
you set the offset value to 90 degrees. I have done it inadvertently. If the
pot is bad it is unlikely to be off by exactly (or close to) 90 degrees
consistently. I had a T2X pot get zapped in one area by lightning and the
display would wander in value when the rotator was pointing in the direction
of the zapped part of the pot (wandering could be anything from correct to
off by +/- 60-70 degrees as I recall).
73, Larry W6NWS
-----Original Message-----
From: Allen R. Brier
Sent: Sunday, February 23, 2014 10:28 PM
To: towertalk@contesting.com
Subject: [TowerTalk] Rotor direction display is 90 degrees off
Is it possible that the pot inside my TailTwister rotor has moved? My
antenna direction on my controller now shows 90 degrees off (to the West)
for some reason. I climbed up the tower and confirmed that the mast has not
slipped in the rotator clamp or at the boom to mast clamp. I checked wiring
connections and all seems to be ok. Did the pot move 90 degrees? Anyone ever
see this before? I would appreciate any advice on this before I go through
the trouble of replacing the rotor with a spare. BTW, I am using a Green
Heron Engineering controller.
Allen R. Brier N5XZ / KL5DX
1515 Windloch Lane
Richmond, TX 77406-2553
281-342-1882 (Home)
713-705-4801 (Cell)
n5xz@earthlink.net
n5xz@arrl.net
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|