I use a 3/4" copper pipe and hose clamp my copper straps to it. That gives
plenty of surface area for a low impedance ground.
On Thu, Mar 20, 2014 at 1:53 PM, Charlie Gallo <[email protected]>wrote:
> Hey Gang,
> Sort of antenna, sort of RFI, more safety..
>
> I've decided my back of desk grounding situation needs to be improved
>
> Now, we all know the standard is a nice, thick copper buss. Question is,
> how thick? - this will then be run down to the panel/ground rod
>
> Is Brass/Aluminum/Copper PIPE a valid alternative? If aluminium, again,
> how large (I normally have round up to about 3" diameter sitting in the
> shop, as well an AL plate (various sizes, 3/16 thick up to 6" wide is
> everyday, and I have angle up to 5" wide legs, 1/4" thick around, and
> blocks up to 2" thick and 4" wide hanging around
>
> I intend to silver braze most of my connections, but obviously that won't
> work to an Al plate, That I'd drill, tap, and either use studs with nuts,
> or screws
>
> Again, we aren't talking the wall pass through here, but the buss at the
> back of the desk
>
> --
> 73 de KG2V - Charles Gallo
> Quality Custom Machine-shop work for the radio amateur (sm)
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> [email protected]
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
[email protected]
http://lists.contesting.com/mailman/listinfo/towertalk
|