I was under the impression that a Yaesu G-1000DXA would control a Yaesu
G-800SDX rotor.
Am I mistaken?
If it is possible can anyone tell me how it should be wired since the 1000DXA
uses 6 wires and the 800SDX uses
only 5.
If it can't be done I have a good 1000DXA controller for sale/
Thanks and 73, Tom k5iid
There is no joy in Mudville!
http://www.dfwcontest.com
K5IID Tom Horton Hillsboro, TX
E sorter for ARRL W5 bureau
Same call for 57 years!
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|