Cordless portable bandsaw
--
73 de KG2V
Charlie
> On Jul 26, 2014, at 1:47 PM, "Victor Walz" <n2pp@frontiernet.net> wrote:
>
> I have a 22 ft (2" OD) heavy duty Cr-Mo mast presently installed up on a 100
> ft Rohn 45 tower. It weighs 200+ pounds. I previously had a 4 el 20 meter
> yagi stacked 12 ft. above a 40 meter F12 yagi. I just finished removing
> both antennas for repairs and have decided not to reinstall the stack due to
> the complexity of the installation. I will be re-installing the 40 meter
> yagi and some VHF antennas on this tower. Consequently, I would like to
> shorten the 22 ft mast by 10 ft.
>
>
>
> I am looking for advice on the most efficient way to cut this very thick
> high strength mast in place. I would prefer to use battery-operated tools
> such as a reciprocating saw(metal blade?) or a grinding tool (cutting
> wheel?). I can run 120 VAC (about 200 ft extension cord) up the tower if
> needed.
>
>
>
> What would be the optimum method for cutting this mast without excessive
> tower time? Thanks in advance for any responses.
>
>
>
> Vic, N2PP
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|