Like these?
http://www.dxengineering.com/parts/dxe-ecls-200
They have other sizes available.
On 11/26/2014 10:30 PM, Wayne Kline wrote:
Another neat trick with a torrid wound balun.
I weld a #10-32 1/2 machine screw to a 2" all stainless hose clamp jus 1" past the end of the tightening slots.
I then drill a hole in the 4" dead center in the bottom of the NEMA Box/ insert the threaded 10/32 machine screw in the hole DEAD center of the wound torid
Instant mounting all my boom are 2" but can install what ever size clam you need .
Wayne
Ps
4 yrs ago I had a wind milling antenna... the coax STRECHED RG-213 ...
ripping the brad and stretching the insulation rg8X size never tor the
center conductor.
the W2FMI build torrid stayed attached to the boom by the #10 machine screw ..
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
--
73,
Gary K9GS
Greater Milwaukee DX Association: http://www.gmdxa.org
Society of Midwest Contesters: http://www.w9smc.com
CW Ops #1032 http://www.cwops.org
************************************************
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|