Im re-cabling a 4 transmitter station and am looking for feedback on what you
are using for interconnect coax after your amplifiers? I'm using double
shielded RG8X for the low power connections to the low power bandpass filters
then to the amplifier inputs. Looking to see if good quality RG213 / RG8
(95-98% shield) is ok past the amps to the high power 4O3A filters or should I
use something like LMR400 / BuryFlex for those connections to keep down the
potential inter-station interference?
Thanks...
Rich
Rich N7TR
ex KI3V, N3AMK, WB3JOV
http://www.qrz.com/db/N7TR
Telnet: dxc.n7tr.com N7TR DXCluster
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|