Later this year I am going to erect a Rohn 45. Before I start this job, I
have been checking everything on the ground to be sure all is good. I
discovered that the bolts that connect the tower sections have been hot
dipped in zinc. They are very tight, and I think that it might be too
difficult to tighten them on the tower when I am 30 feet or higher. Should
I take a tap and die to clean out the threads? Lock washers were not
included. Should I get some zinc ones before I start this job?
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|