This is for an earlier version, but I think you will find it applicable.
http://www.rogerhalstead.com/Gears.htm
Good luck.
73
Roger (K8RI)
On 5/4/2016 Wednesday 10:18 AM, Art wrote:
Hello,
Does any one know how to separate the gear from the housing after the 8 bolts
are removed? I need to replace the shear pin and although I can loosen the
gear I cannot remove it.
Thanks,Art - W1AJT
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
--
73
Roger (K8RI)
---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|