If those fine wires expand, I simply place them between my thumb and
forefinger and twist.
So far it has always worked, but there is a small learning curve.
73
Roger (K8RI)
On 6/8/2016 Wednesday 7:46 PM, Mark Spencer via TowerTalk wrote:
To close the loop on this.
I did work out a fairly consistent process to strip the centre conductor on RG
400 style cable while preventing it from expanding. I found if I cut the
centre conductor to length with cable cutters (as opposed to my wire cutters)
with the dielectric still attached, it was much less likely to expand. (Or if
it is expanding a small amount, the current batch of connectors I have still
fit the cable I am using (: )
I recall using a similar approach with Belden 9913F7 some time ago.
Thanks again for all the suggestions.
73
VE7AFZ
Sent from my iPhone
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
--
73
Roger (K8RI)
---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|