| 
I've said it many times, I used to feel like you toward connectors, 
until a direct lightning strike to the top of my tower removed all of 
the weatherproofing and 15 minutes later I had water running out of my 
rig onto the desk top. It didn't hurt the rig, but it ruined the desk 
top.  40 years total at 3 locations with nary a problem, but one strike 
ruined 200 feet of 9913, IIRC 8 connectors, and a desk top 
If you are on HF, Unless it is a long line, or you consider the legal 
limit as QRP, as far as I can see, there is little to be gained from 
using these expensive cables
I found 1/2" Heliax too fragile for kinking, or being stepped on. I gave 
away two 100' runs with connectors. and went to LMR600. Now if I could 
have found 7/8ths Heliax at a reasonable price, I would have used it for 
VHF and UHF.  The only time I saw a good price was a pick up load for 
the repeater that was free free, but none as an individual. 
Total length from my rigs to the top of the tower was 200 feet with 
rotator loops and 28' pigtails to the antennas 
73
Roger (K8RI)
On 9/7/2016 Wednesday 7:50 PM, Kevin wrote:
 I believe it all started with the superiority of heliax/hard-line from 
a loss perspective and since UHF type connectors for such cable are 
expensive and rare why not use 7/16 DIN, a commercial standard connector.
On 9/7/2016 10:26 AM, StellarCAT wrote:
 Forgive me - I've replied to Gerald's email but this is directed to 
the thread in general: WHY all the concern for sealed connectors and 
connector types? I've been using UHF for 49 years and the only time 
I've had issues with those installed outside it was my fault - either 
poor wrap of tape or poor solder job ... I've had cables with 
connectors that were out for years with electrical tape wrapped 
around them in 2 directions - years later when disassembling them for 
a move they were utterly pristine! I don't get it - why so much 
discussion?
Gary
K9RX
-----Original Message----- From: TexasRF@aol.com
Sent: Wednesday, September 7, 2016 8:56 AM
To: john@kk9a.com ; towertalk@contesting.com
Subject: Re: [TowerTalk] LMR600 male DIN
John, you bring up a valid concern. I am not aware of any coaxial type
connector that could be considered waterproof. The fundamental reason is
because  the threaded connections do not create a hermetic seal when 
they are 
screwed  together.
There are inevitable air spaces inside the connectors and coaxial 
cables.
These air spaces will fill with air. When the air is heated (like 
outside
in full sun) it will expand, creating a positive pressure. 
Conversely, when 
the air cools (like at night), it will create a negative pressure. This
negative pressure will suck tiny amounts of water vapor through the 
threads of 
the connector.
If enough water vapor is present droplets of water can condense 
during  the
cooling cycle and over the course of days and weeks can collect 
inside the 
connector. Once inside, there is no escape and the droplets continue to
collect  over time.
If there are rain or dew drops of water on the outside of the cable, 
they
can also leak through the threads and collect inside the connector. 
Gravity 
is  not your friend here.
Many commercial applications pressurize all of the cables even if 
they are
foam filled types to prevent the problem. You may have noticed many 
of the 
Heliax type connectors have air fittings; that is why.
73,
Gerald K5GW
Over
In a message dated 9/7/2016 5:37:52 A.M. Central Daylight Time,
john@kk9a.com writes:
Is any  TX connector really water proof?  Are DIN's being professionally
installed with no external butyl rubber and tape? On the two outdoor 
DINs
that I have, I weather proofed the connection the same way I did with 
UHF 
and N connectors.
John KK9A
To:     towertalk@contesting.com
Subject:    Re: [TowerTalk] LMR600 male  DIN
From:    "Roger (K8RI) on TT"  <K8RI-on-TowerTalk@tm.net>
Date:    Wed, 7 Sep 2016  01:08:48 -0400
Take care!
According to the Amphenol page N-Type are  not water proof/weather 
proof. 
73
Roger  (K8RI)
_______________________________________________
_______________________________________________
TowerTalk  mailing  list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
 
 
--
73
Roger (K8RI)
---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
 |