Its good you didn't find 1/8" wall aluminum, you want 1/4" wall!
David Robbins K1TTT
e-mail: mailto:k1ttt@arrl.net
web: http://wiki.k1ttt.net
AR-Cluster node: 145.69MHz or telnet://k1ttt.net:7373
-----Original Message-----
From: TowerTalk [mailto:towertalk-bounces@contesting.com] On Behalf Of Ed
Stallman
Sent: Friday, March 24, 2017 19:51
To: towertalk@contesting.com
Subject: [TowerTalk] Gen Pole 10ft x 2in OD mast pipe
I'm in need of a 2 in OD mast pipe for my Gen Pole . I was looking at EMT
but I see the wall thickness is .065 . I will be lifting 115LB's , I will
have a pulley at the bottom of the tower so the rope will be pulling striate
down .. I'm not sure if EMT is strong enough for this job ? Anyone have a
recommendation , something better then EMT . 2 inch OD 1/8 wall aluminum in
a 10ft length is hard to find .
Thanks Ed N5DG
---
This email has been checked for viruses by AVG.
http://www.avg.com
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|