| To: | <[email protected]> |
|---|---|
| Subject: | [TowerTalk] Rohn 25 question |
| From: | "Gary Johnson" <[email protected]> |
| Date: | Thu, 15 Jun 2017 19:54:28 -0500 |
| List-post: | <mailto:[email protected]> |
I was given 6 sections of Rohn 25 that some idiot with a sawzall disassembled by cutting off the ears that fit into the next section vs unbolting. Is it possible to remove the bolted in ears and reassemble using a section of pipe the correct diameter bolting it both above and below?? 73 Gary J N5BAA _______________________________________________ _______________________________________________ TowerTalk mailing list [email protected] http://lists.contesting.com/mailman/listinfo/towertalk |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TowerTalk] Antenna & Tower Wind Load Ratings, Al Kozakiewicz |
|---|---|
| Next by Date: | Re: [TowerTalk] Rohn 25 question, w5prchuck |
| Previous by Thread: | [TowerTalk] Loudon County VA and surrounding areas - tower regulations?, K2CB |
| Next by Thread: | Re: [TowerTalk] Rohn 25 question, w5prchuck |
| Indexes: | [Date] [Thread] [Top] [All Lists] |