Agreed...it's scrap metal now.
Maybe if you were using 30' for field day or something, but more than that?
Nope.
Chris
KF7P
On Jun 16, 2017, at 1:00 PM, Mike Ricketts wrote:
> On something as important as the tower structure, I would even risk putting
> it up with this type of reworking of the assembly between sections, but
> that's just my opinion.
>
> For the cost, and generally common availability, I would just find another
> set of sections. Maybe keep one, if you were planning on sinking one of
> them as the base section, and sell the rest for scrap to offset the cost of
> the replacement set.
>
>
>
> 73,
> Mike ND9G
>
> On Thu, Jun 15, 2017 at 7:54 PM, Gary Johnson <n5baa@hctc.net> wrote:
>
>> I was given 6 sections of Rohn 25 that some idiot with a sawzall
>> disassembled by cutting off the ears that fit into the next section vs
>> unbolting. Is it possible to remove the bolted in ears and reassemble
>> using a section of pipe the correct diameter bolting it both above and
>> below??
>>
>> 73
>>
>> Gary J
>> N5BAA
>> _______________________________________________
>>
>>
>>
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk@contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
>>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|