Towertalk
[Top] [All Lists]

[TowerTalk] Wire Antennas Only For Field Day

To: "towertalk@contesting.com" <towertalk@contesting.com>
Subject: [TowerTalk] Wire Antennas Only For Field Day
From: Russ Dearmore via TowerTalk <towertalk@contesting.com>
Reply-to: Russ Dearmore <champsruss@yahoo.com>
Date: Wed, 5 Jul 2017 18:03:02 +0000 (UTC)
List-post: <mailto:towertalk@contesting.com>
  I was wondering if in the past FD was regulated to only wire antennas.  It 
would seem to be a way to level the playing field for all participants and add 
a stealthy aspect to the weekend.  There's something about aluminum beams and 
even verticals that seem a bit out of place when considering that we are 
practicing for dire emergency situations.  Although I don't see us being 
invaded anytime soon (Hi) the added consideration would give a bit more meaning 
to the exercise...  Possibly an additional weekend contest with these points 
emphasized or additional points awarded in some manner to the existing field 
day.  (I haven't read all the rules on FD so please forgive me if those rules 
already exist).  By the way I'm not suggesting that anyone is doing anything 
improper by using aluminum.     A fun sprint type contest would be to use 
battery powered radios like military models until all batteries expired.  Just 
some ideas to challenge us to improve our sport...   Russ  K5ZZR 

          

      From: "towertalk-request@contesting.com" 
<towertalk-request@contesting.com>
 To: towertalk@contesting.com 
 Sent: Tuesday, July 4, 2017 11:01 AM
 Subject: TowerTalk Digest, Vol 175, Issue 10
   
Send TowerTalk mailing list submissions to
    towertalk@contesting.com

To subscribe or unsubscribe via the World Wide Web, visit
    http://lists.contesting.com/mailman/listinfo/towertalk
or, via email, send a message with subject or body 'help' to
    towertalk-request@contesting.com

You can reach the person managing the list at
    towertalk-owner@contesting.com

When replying, please edit your Subject line so it is more specific
than "Re: Contents of TowerTalk digest..."
Today's Topics:

  1. Re: Field Day (Kim Elmore)
  2. Re: Field Day (Ed Sawyer)
  3. Re: Field Day (Kim Elmore)
At our club we make certain that our dipoles are strung end-to-end at 
nearly the same height. We also make liberal use of common mode chokes 
on both ends the the transmission lines for each station. This seems to 
work for us relatively well as we can usually operate phone and CW on 
the same band without much, if any, interference. I always run CW and I 
sometimes hear some trash form the phone station. This year we traced it 
down to a philosophy of "all knobs to the right" on the phone 
transmitter (an IC-7300). I was using  my Kenwood TS-930S with the INRAD 
roofing filter in the 40 MHz IF. With that mod, it has become a pretty 
stout receiver, on par with my Orion II ( which I've had to FD in the 
past) if the signals are ~100 kHz apart. More separation would always 
help, but we'd still strive to keep the dipoles end-to end and at nearly 
the same height.

Kim Elmore N5OP

On 7/3/2017 11:13 AM, Jim Thomson wrote:
> Date: Mon, 3 Jul 2017 06:52:42 -0700
> From: Grant Saviers <grants2@pacbell.net>
> To: "towertalk@contesting.com" <towertalk@contesting.com>
> Subject: Re: [TowerTalk] Field Day
>
> <We (N7KE) haven't had the lack of interference others note re same band
> <operation on FD.  So am looking for ideas about what to chase or improve.
>
> <Operating 2A on two separate generators - Honda inverter 1000EU, no
> <interconnections of stations
>
> We experience lot's of buzz from cw into ssb, need to get as far up the
> band as possible.  Reverse also true.  About the same level of trouble
> as last year with the beams 75' closer together.
>
> Tried a new vertical 40m dipole this year on ssb and noticed less
> problems, which was expected with the crossed polarization.
>
>
> Any designs for 100w same band filters appreciated.
>
> Grant KZ1W
>
> ##  band pass filters, each being 7000-7300, probably are not going to do 
> much good,
> if 2 x xcvrs used on the same band, say 40m cw..and 40m ssb.  Heres a thought 
> though.
> I see ICE and others make band pass filters for the warc bands, like 100 khz 
> wide for 17+12M,
> and only 50 khz wide for 30M band.    If they can make a 50 khz wide band 
> pass filter for 30M
> band, they, or somebody should be able to make any BW  filter you want.    
> IE:  say 7000-7050,
> or  7000-7075  for  40m CW.... then  perhaps 7100-7300 for  40m ssb, or 
> perhaps  7150-7300,etc.
>
> ##  Or perhaps an LP filter  for 40m CW..with a sharp cut off at  whatever 
> upper freq u want, like perhaps
> 7050, 7070, etc.    Then say a HP  filter, again with a sharp cut off, for  
> 40M  ssb, like 7100 khz.
>
> ##  6 or 8 pole xtal filters, custom made, might be of some benefit...on RX 
> only. Same deal, like  7000-7070
> etc, for cw....and something similar for 40m SSB.  But if the 40m  SSB 
> station has broadband TX IMD,
> the CW station  will still RX the imd,  but less of it.
>
> ##  I believe a band pass filter is just a combo LP + HP filter in series.  
> Perhaps a bandpass filter for 40M
> cw use, but with a sharper cut off for the LP filter portion.  And a band 
> pass filter for 40M SSB, but with a
> sharper cut off for the HP filter portion.  Band pass  filters that would 
> handle 100-200 w, with the above
> narrow widths, might well chop off some of the broad band trash, hash, buzz, 
> imd,clicks, etc on  TX.
>
> ##  A stand alone, tunable high Q RX pre-selector might be of some benefit.  
> The TX imd on ssb, with the K3
> running 100w out, will not be wonderful on the CW stations K3...on RX.  This 
> is where you want  real low TX
> IMD...on ssb....and no clix at all on cw.
>
> Jim  VE7RF
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>

-- 

Kim Elmore, Ph.D. (Adj. Assoc. Prof., OU School of Meteorology, CCM, PP 
SEL/MEL/Glider, N5OP, 2nd Class Radiotelegraph, GROL)

/"In theory there is no difference between theory and practice. But, in 
practice, there is." //– Attributed to many people; it’s so true that it 
doesn’t matter who said it./


I have done quite a bit of "in band" low power 2 radio work.  At 100 W, 2 A4
tribanders, tip to tip, 225ft separation  should have still audible sounds
on the cross band portion CW vs SSB - maybe 2 - 3 S units.  However 10 -
15dB of attenuation on the receivers should kill it if it becomes
bothersome.  If you are not seeing that, consider grounding the systems
together and trying other radios (making sure the SSB radio is not over
driving).

 

I have cross polarized 10, 15, 20M systems that are separated by 200 - 400
feet and they are virtually silent on the noise floor 25khz away - same mode
band - using 100W.  Using amps, you can hear them but the 15dB of pad kills
it.

 

On 40 - 160, try running a long - directional beverage, separated and to the
side of the antenna if you have the room.  At 100W, and with the improved
S/N ratio, you should do really well.  Potentially both stations could use
the same beverage for receive.

 

Ed  N1UR



'Zactly. The value of 10-15 dB of attenuation can work wonders.

Kim N5OP


On 7/4/2017 5:48 AM, Ed Sawyer wrote:
> I have done quite a bit of "in band" low power 2 radio work.  At 100 W, 2 A4
> tribanders, tip to tip, 225ft separation  should have still audible sounds
> on the cross band portion CW vs SSB - maybe 2 - 3 S units.  However 10 -
> 15dB of attenuation on the receivers should kill it if it becomes
> bothersome.  If you are not seeing that, consider grounding the systems
> together and trying other radios (making sure the SSB radio is not over
> driving).
>
>  
>
> I have cross polarized 10, 15, 20M systems that are separated by 200 - 400
> feet and they are virtually silent on the noise floor 25khz away - same mode
> band - using 100W.  Using amps, you can hear them but the 15dB of pad kills
> it.
>
>  
>
> On 40 - 160, try running a long - directional beverage, separated and to the
> side of the antenna if you have the room.  At 100W, and with the improved
> S/N ratio, you should do really well.  Potentially both stations could use
> the same beverage for receive.
>
>  
>
> Ed  N1UR
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>

-- 

Kim Elmore, Ph.D. (Adj. Assoc. Prof., OU School of Meteorology, CCM, PP 
SEL/MEL/Glider, N5OP, 2nd Class Radiotelegraph, GROL)

/"In theory there is no difference between theory and practice. But, in 
practice, there is." //– Attributed to many people; it’s so true that it 
doesn’t matter who said it./


_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk


   
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
<Prev in Thread] Current Thread [Next in Thread>