Towertalk
[Top] [All Lists]

Re: [TowerTalk] SO2R or Multiop Contesting without interference

To: towertalk@contesting.com
Subject: Re: [TowerTalk] SO2R or Multiop Contesting without interference
From: Jim Brown <jim@audiosystemsgroup.com>
Reply-to: jim@audiosystemsgroup.com
Date: Mon, 28 May 2018 21:45:42 -0700
List-post: <mailto:towertalk@contesting.com>
On 5/28/2018 7:32 PM, Timothy Coker via TowerTalk wrote:
Is anyone out there operating high power SO2R or Multi-Op without interstation 
interference (besides being on or very near a harmonic)?

If you mean none, no. But there are LOTS of variables, some of which can be controlled and others that cannot.  Take a look at k9yc.com/7QP.pdf and see what we've done in W6GJB's contesting trailer.  With 20M Yagi, 40M dipole, and 80M inverted Vee we can operate on harmonically related bands and hear only our harmonic. Same at home. Each station is a K3 w/new synth, 87A This weekend, I was running SO2R on 20 and 15 with 3-el SteppIR and 4-el home brew with no interference. Also worked 40 and 20 with 2-el 40M wire Yagi about five ft below the SteppIR. The 40M has double stubs per this app note.

http://k9yc.com/LocatingStubs.pdf

In the trailer are double stubs on both 80 and 40, same careful placement. Each station is K3/P3/KPA500/KAT500.

My station has 5B4AGN bandpass filters, Glen's trailer has W3NQN filter sets bought from Array Solutions, maybe 10 years ago. They belong to another team member, N6RNO. In both stations there are serious ferrite common mode chokes at the feedpoint of every antenna.  NO offbrand/unbranded junk connectors or adapters. Serious attention to bonding in the shack and everywhere else.

BUT -- no matter how clean your filtering and stubs and rigs are, passive intermod outside the shack can and will generate and reradiate "growly" harmonics.  Two years ago, we had the trailer in a VERY isolated place Trinity Co spot for CQP on Saturday. TOTALLY clean.  Next day parked alongside I-5 in Colusa Co, we had growlies galore. The nearest homes/biz were probably a quarter to a half mile away.  Last year WAY off the beaten path in Tuolemne Co we had bad growlies. We suspect a cell site perhaps a half mile away, or one of several RVs parked within a quarter to a half mile away.

W3LPL has identified one common growly generator as the internal junction between boom and mast, which N6RK confirms. The fix is to bond around it. W3LPL also lists SMPS as a common cuplrit.

AND -- SERIOUS attention to every piece of coax, every connector, every piece of gear in the signal chain matters. Several years ago, I wasn't getting the suppression from stubs that SimSmith told me I should, so I bought a spool of BuryFlex and a bag of 100 83-1SP connectors and replaced every patch cable in the shack. I didn't measure the difference, but it wasn't subtle.  Hard line has at least important benefits  -- 1) low loss, 2) varmint proof, and 3) spectacularly good shielding. #3 minimizes coupling of RF picked up on the shield to the center conductor by a mechanism quantified as the "transfer impedance" of the shield, which is defined as the differential voltage INSIDE the coax divided by the common mode current on the shield. A low number is better, and the lower limit is the resistance of the shield at the frequency of interest.  It also depends on the uniformity of the shield.

A few years ago, I did a search and destroy for SMPS around my home, mostly replacing with linear supplies. For a few built into equipment I added serious common mode chokes to the AC cable.  Every audio and video cable in our living room has chokes on it.  This is everything from modems to Ethernet to refrigerators. :)  In addition to the "growlies" they also generate noise.

I read reviews of various antennas, new filters, etc of having non-existant 
issues. However, in my limited experience it seems that tribanders will have 
these issues even with the latest high power triplexors and band pass filters. 
Even problems will arise at multi-tower stations with monoband yagi stacks 
and/or different direction facing yagi's.
Has anyone got the ability to say that they are trouble free on their various 
band combinations?

For instance, at home I have lots of interference when receiving on 15m and 
while transmitting on 20m. Same goes when receiving on 20m and transmitting on 
40m. For me, it can be both direction and/or antenna limited depending on what 
band combination and which tribander that I take out of the stack.

I have no tribanders but I do have a tower with 3-el 20M about 15 ft above 4-el on 15M. My SteppIR at 120 ft is my best antenna, and when working 15/20, put it where I think it will do the most good. Sometimes though I'll point that stack in a direction from where the Yagi is pointed to run two directions at the same time. For example, this weekend, I was running northern EU on 20 for hours at a time with the SteppIR aimed to about 10 degrees, and the Yagi at 305-315 degrees to copy weak JAs. And sometimes I'd be running on one of the monobanders, then switch to the other one so I was TX on one of them and RX on the other. I heard some small transients, but no serious interference between them.

I DO have crossband issues with Beverages. They have chokes, but no BPF. They're on my wish list. :)

I'm curious about the true confessions that other operators have about what 
they are dealing with when transmitting on multiple bands at once? Have some of 
the stations got this under control? If so is it mainly the big property owning 
stations with many towers or have guys on 1-2 tower setups quelled this also?

One of the benefits of property is putting space between you and noise sources. :)  My two towers are about 200 ft apart. I have a pair of dipoles for 80M at 90 degrees to each other, and one end of both is about 140 ft up in a redwood. One those two dipoles, broadside to JA, has a fan element for 40M. They don't play well together. :)

Bottom line -- when we're trying to get 100 dB below your 1500W TX signal, EVERY tiny detail adds up. It's like peeling an onion -- big problems obscure little ones, you fix those and then you can chase the smaller ones.

N6DQ lost his fight with cancer about a year ago, and his widow, K6YL, wants to sell what I think is a complete set of 403A high power filters and high power triplexer. They were used in a trailer that they built and used together.  Joanna is a pillar of NCCC, serving several terms an officer and handling awards for both CQP and club operating.

73, Jim K9YC


_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
<Prev in Thread] Current Thread [Next in Thread>