looks like the right connector for my 4 cond rotor cable . ( orion2800)
At 04:05 PM 7/30/2018, Clay Autery wrote:
Used them in a race car I built one time for all
the Autronics compute signal and power
wires... Worled great, and loads better than
OE automotive connectors. You DO need to pay
particular attention to terminating and putting
seals in properly. And true to my OCD self, I
flooded the connector cavities with non-drying,
water-excluding gel right before
assembly. Never had a failure. 73,
______________________ Clay Autery, KY5G (318)
518-1389 On 30-Jul-18 14:23, Don wrote: > Wonder
if anyone has any experience using these: > >
http://www.te.com/content/dam/te-com/documents/automotive/global/1654292-2_AMP%20SUPERSEAL%201.5.pdf
> > > Seems like they could have some
application to all the non-RF type > connections
made by we hams outdoors, particularly in open
conditions. > > > Don T W7WLL > >
_______________________________________________ >
> > >
_______________________________________________ >
TowerTalk mailing list >
TowerTalk@contesting.com >
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk </x-flowed>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|