I checked in one spec of the T2X rotor and says can drive pipes up to 2-1/8”,
so the shims should be 1/16” each for a 2” pipe.
Also check if rotor base is centered on the tower’s base.
Fernando,XE2FL
Fernando José Muguerza,XE2FL
Cel. 81.1589.2930
Email. [email protected]
Email. [email protected]
Enviado desde mi iPhone
Inicio del mensaje reenviado:
> De: FERNANDO MUGUERZA VIDEGARAY <[email protected]>
> Fecha: 15 de diciembre de 2018, 23:46:45 GMT-6
> Para: [email protected]
> Asunto: MA40 and T2X rotor off center
>
> I think the reason for the wooble of the rotor output is because the rotor
> is capable of turning Antenna’s pipes up to a list 2-3/8” in diameter,if one
> uses 2” pipes,since one of the grips is fixed with the base of the rotor and
> the other is movable to clamp,the shaft will be off center,unless you
> shim(3/16”) both sides to make to be centered in this case!
> Fernando,XE2FL
>
>
> Fernando José Muguerza,XE2FL
> Cel. 81.1589.2930
> Email. [email protected]
> Email. [email protected]
>
> Enviado desde mi iPhone
_______________________________________________
_______________________________________________
TowerTalk mailing list
[email protected]
http://lists.contesting.com/mailman/listinfo/towertalk
|