OK Dave, point well taken!
But the only time I've worked anyone right at the noise level was when Dima
RA9USU sucked my CW signal out of the noise when he was at E30FB. Took him 10
tries to finally get my call. I admit 1 dB might have made a difference for
that Q!
73,
Steve
-----Original Message-----
From: TowerTalk <towertalk-bounces@contesting.com> On Behalf Of David Gilbert
Sent: Thursday, April 30, 2020 4:58 PM
To: towertalk@contesting.com
Subject: Re: [TowerTalk] 1dB more RF Power?
True ... although noise doesn't care when or where you put your signal, and 1
dB can sometimes make a valuable difference if you happen to be right at the
level of the mud.
And, of course, there is always the possibility that the folks you're competing
against are just as adroit in signal placement as you are. If there are enough
of them 1 dB could matter then as well.
73,
Dave AB7E
On 4/30/2020 12:12 PM, n6sj@earthlink.net wrote:
> Great discussion!
>
> But personally, I think on CW your timing (call early, call late),
> keying speed (call faster, call slower), and placement of your signal
> in the receiver's passband (call high, call low) will all have a much
> bigger effect on being noticed and answered than a 1dB increase in RF signal
> power.
>
> On SSB your timing, mic equalization, enunciation, and inherent voice
> timbre will similarly swamp a 1dB power increase.
>
> 73,
> Steve
> N6SJ
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|