Phil-
I never tried it on ss cable, but if you have a Dremel tool, try cutting
it with one of their very thin cutoff wheels. I have a feeling that
might work. I have easily cut off 1/8" nails coming out of a board whose
other side I could not get to in order to remove it.
Dick, K0CAT
=================================
Phil wrote on 6/27/2020 3:08 PM:
Any recommendations? I was thinking about taping
the place for the cut with electrical tape and then
wedging it in a piece of copper tubing....
thanks, 73, Phil W5BVB
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
//
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|