On 7/21/2020 2:49 PM, jimlux wrote:
Or 4 nuts - nut1 wire nut2 pvc nut3 wire nut4
The preload between nut1 and nut2 and the preload between nut3 and
nut4 are what make the contact. Takes two wrenches to get it tight
enough.
Speaking of which, it's hard to find wrenches thin enough to lock two
6-32 or 8-32 nuts together. I have one old, cheap, Craftsman set that
works, but sooner or later I'm going to lose one of those up on the
tower. All the small wrench sets ("Ignition Wrenches") available seem to
be too thick. Short of grinding them down, does anyone know where to get
thin ones in SAE sizes?
73,
Scott K9MA
--
Scott K9MA
k9ma@sdellington.us
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|