Gang.
I went to page 16 of the MFJ-259B analyzer and selected 5.5 distance to default
mode.
This is the mode that tells you the distance to fault in feed.
I pushed the mode button to get to the correct advanced mode.
The 259B went through the following operations...
Capacity
Inductance
freq counter
impedance R & X
coax loss
and then started over so I never find the distance to fault mode in feet
This is supposed to tell me where in the coax I have a problem. What am I
missing?
73 Dave K4JRB
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|