This video will help you.
https://youtu.be/-TOyeaOfawg <https://youtu.be/-TOyeaOfawg>
An Evening with Martin F. Jue
MFJ's Antenna Analyzers
Using the MFJ-269 to Test Coaxial Cables, Part 1 of 2
at Ga Tech, February 25, 2010
> On Aug 13, 2020, at 8:00 AM, Dave Thompson <thompson@mindspring.com> wrote:
>
> Gang.
>
> I went to page 16 of the MFJ-259B analyzer and selected 5.5 distance to
> default mode.
>
> This is the mode that tells you the distance to fault in feed.
>
> I pushed the mode button to get to the correct advanced mode.
>
> The 259B went through the following operations...
>
> Capacity
> Inductance
> freq counter
> impedance R & X
> coax loss
>
> and then started over so I never find the distance to fault mode in feet
>
> This is supposed to tell me where in the coax I have a problem. What am I
> missing?
>
> 73 Dave K4JRB
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|