I have refurbished an old Ham IV and now am in the proces of
re-assembling it. What is the correct way to align the Bell Housing so
that the rotator will be on an end stop. I cannot find any assembly
instructions nor Youtube videos which cover this part. I just wondered
if there were any specific tricks or pitfalls to be avoided, once I
start withg the grease and ballbearings. I had a fault with the wedge
brake which now appears to be free and working normally.
Tom
GM4FDM
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|