I followed the procedure in this manual a couple of months back and it worked
just fine:
http://www.radiomanual.info/schemi/ACC_rotator/CDE_HAM-4_user_W0MTU.pdf
de KM1P Joe
________________________________________
From: TowerTalk <towertalk-bounces@contesting.com> on behalf of Tom Wylie
<thomasgwylie@gmail.com>
Sent: Tuesday, December 29, 2020 2:29 PM
To: TowerTalk
Subject: [TowerTalk] Rotator Advice
I have refurbished an old Ham IV and now am in the proces of
re-assembling it. What is the correct way to align the Bell Housing so
that the rotator will be on an end stop. I cannot find any assembly
instructions nor Youtube videos which cover this part. I just wondered
if there were any specific tricks or pitfalls to be avoided, once I
start withg the grease and ballbearings. I had a fault with the wedge
brake which now appears to be free and working normally.
Tom
GM4FDM
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|