I do not loosen the opposing guys on my Rohn 55 and Rohn 65 when dropping
one for antenna installation however I am not a tower engineer and cannot
recommend that anyone else do this.
John KK9A
Ignacy Misztal no9e wrote:
I am hoisting JK Mid Tri (100 lb) to 65' on a 100' 45G. There are 3 sets of
guy wires at 32', 62' and 95'. I am not clearing one guy at 62'. If I
remove that guy wire, should I loosen the other guy wires at 62', to avoid
potential bending?
Ignacy NO9E
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|