Coax arms with a top curved arm to act as a strain relief. This a a lot easier
to swap out cables and troubleshoot down the road.
https://www.kf7p.com/KF7P/CoaxArms.html
<https://www.kf7p.com/KF7P/CoaxArms.html>
Chris
KF7P
> On Oct 7, 2021, at 11:59 AM, al.n6ta@gmail.com wrote:
>
> I know what they are and do not need one for pulling thru conduit. But I
> would like a clean way to support the 70' of cable going up to the top of my
> DX-70 telescoping tower.
>
> The question is if it is bad form to put more than one cable into the grip.
> I understand that the braid will not fully contact any one cable. The only
> reason to consider mor than one per grip is that they seem to cost over $30
> each.
>
> Any alternate common method to support cables would be appreciated. I
> suppose good tape on top section is always an option. Using one RG217, one
> rotator cable and one 24 conductor for DB36 control.
>
> Thanks.
>
> Al
>
> N6TA
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|