Hi, Joe.
Detuning a tower and shunt feeding a tower seem to be essentially the
same mechanism except for whether there is a feed or not, and I've often
wondered why running a wire down the center of a tower wouldn't create
the same coaxial section as surrounding the tower with multiple wires.
Has anyone successfully tried this? I couldn't find much of anything by
searching online.
Take care es 73,
Dave AB7E
On 1/2/2024 7:17 AM, Joe Subich, W4TV wrote:
A tuned skirt is a detuning kit. In essence, the skirt is a coaxial
section while a single wire is an open wire line. They work the
same way short one end, tune the open end with the appropriate
reactance (capacitor). If one knows the Zo of the line section,
determining the starting capacitance is straightforward.
I would prefer a three or six wire skirt for detuning simply because
it is easier to calculate the effective diameter(s) of the triangular
tower section and the skirt. Any errors should be systematic and
the *ratio* of the two diameters will be consistent. However, either
the single wire (loop) or skirt will work to detune a tower.
73,
... Joe, W4TV
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|