Hi all,
I have an old Mosley TA-33-M that I picked up last year at Dayton.
I did some reconditioning last year before I put it up. cleaning with TSP
and inspecting the coils.
Two or three of the coil forms had either cracked or broken, and I
reassembled them with a vice and epoxy.
That lasted through last winter, but I am thinking I should do something
better while I have good weather.
I saw a 3D print stl online by SA2CLC for TA33JR forms that I was
considering printing in ABS, but I did not know if the coil forms were
identical, and I could not find any discussion around that. I wonder if
anyone on the list has experience with TA33JR vs TA-33-M coil forms.
Thanks
Mark
W8GU
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|