Towertalk
[Top] [All Lists]

Re: [TowerTalk] Mosley coil forms

To: "towertalk@contesting.com" <towertalk@contesting.com>
Subject: Re: [TowerTalk] Mosley coil forms
From: Gary Mayfield <gary_mayfield@hotmail.com>
Date: Fri, 2 Aug 2024 11:35:06 +0000
List-post: <mailto:towertalk@contesting.com>
Our club has both antennas - the coils are different ☹

73,
Joe kk0sd

-----Original Message-----
From: TowerTalk <towertalk-bounces@contesting.com> On Behalf Of 
mark@sladenfamily.com
Sent: Friday, August 2, 2024 6:16 AM
To: towertalk@contesting.com
Subject: [TowerTalk] Mosley coil forms

Hi all,



I have an old Mosley TA-33-M that I picked up last year at Dayton.



I did some reconditioning last year before I put it up. cleaning with TSP and 
inspecting the coils.



Two or three of the coil forms had either cracked or broken, and I reassembled 
them with a vice and epoxy.

That lasted through last winter, but I am thinking I should do something better 
while I have good weather.



I saw a 3D print stl online by  SA2CLC for TA33JR forms that I was considering 
printing in ABS, but I did not know if the coil forms were
identical, and I could not find any discussion around that.   I wonder if
anyone on the list has experience with TA33JR vs TA-33-M coil forms.



Thanks

Mark

W8GU



_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
<Prev in Thread] Current Thread [Next in Thread>