Wes isn't modeling inductive loading ... he's modeling a series resistor
in the feed. It's a matching network, not a loading coil in the
element. He's comparing apples and walnuts.
Dave AB7E
On 7/4/2025 11:30 AM, Jim Brown wrote:
On 7/4/2025 8:39 AM, Wes wrote:
I "built" a model of a vertical in AutoEZ and used EZNEC Pro/2+ V 7.0
running the NEC 5 engine to do the computations.
All good, but -- one of the things that long QEX piece showed is that
EZNEC doesn't correctly model inductive loading! They did this by
comparing the modeling result with measurements of built antennas.
73, Jim K9YC
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|