Don,
During the all 14 grids attempt, will you only work me
so you quality as a captive rover?
73s John NE0P
--- "Donald M. Ross" <dross@sirinet.net> wrote:
> Hi George,
>
> I have used the KB6KQ loops for several years
> (learned about them from ND2X)
> without any problems.
>
> Around town, I usually run just one of them mounted
> in the left rear stake
> mount on a GeoTool mount. When roving for fun or
> contesting, I run dual
> loops mounted in the same place. The dual loops
> appear to "hear" better and
> I get better reports when running them than with a
> single loop. Due to the
> mounting configuration, I cannot do instant
> switching between single and
> dual loops, but can make the switch in about 2
> minutes. I normally run the
> single loop with 25 - 40 watts, depending on the
> radio in use, but run the
> large TE Systems amp (400w on my Bird) with the dual
> loops. You and I have
> worked with this configuration before (EM04 to EM00
> for the rest of you). A
> friend of mine, NH6CJ, runs the M2 Loop and we have
> operated them side by
> side on the top of Mount Scott (EM04rr) several
> times. I won't comment on
> whether one of them is "better" than the other since
> the antenna is only
> part of the total station configuration and there
> were no matching
> components between our two stations. Mike loves his
> M2 Loop and I love my
> KB6KQ loops.
>
> I have used the M2 2M9SSB both portable and
> permanent and really like the
> antenna. While not as good as the 2M18XXX straight
> up in a fixed location,
> it is a solid performer and breaks apart easily for
> moving between sites.
> For June, I'm going to run the single 2M9SSB, but
> will probably try dual
> ones for the July contest as I attempt to put all 14
> Oklahoma grids on the
> air.
>
> Hope this topic draws as many responses as the
> captive rover one did.
>
> 73, Don, NL7CO/EM04
>
> -----Original Message-----
> From: vhfcontesting-bounces@contesting.com
> [mailto:vhfcontesting-bounces@contesting.com]On
> Behalf Of George Fremin III
> Sent: 03 May 2003 15:08
> To: vhfcontesting@contesting.com
> Subject: [VHFcontesting] 2 meter antenna question.
>
>
> Is there anyone who uses an omni directional or near
> omnicirectional
> antenna in their VHF contest station on 144mhz or
> higher?
>
> If so - what are you using or what have you tried?
>
> Is anyone using more than one yagi or yagi arrays
> that
> is either fixed or on seprate towers/masts?
>
> If so - what are you using and why?
>
> If you have two yagis or yagi arrays do you have or
> have you
> had switching that would allow you to run both
> systems
> at one time so that you can listen and transmit in
> more
> than one direction?
>
> What worked or didnt' work?
>
> --
> George Fremin III - K5TR
> geoiii@kkn.net
> http://www.kkn.net/~k5tr
>
>
> _______________________________________________
> VHFcontesting mailing list
> VHFcontesting@contesting.com
>
http://lists.contesting.com/mailman/listinfo/vhfcontesting
>
> _______________________________________________
> VHFcontesting mailing list
> VHFcontesting@contesting.com
>
http://lists.contesting.com/mailman/listinfo/vhfcontesting
__________________________________
Do you Yahoo!?
The New Yahoo! Search - Faster. Easier. Bingo.
http://search.yahoo.com
|