VHFcontesting
[Top] [All Lists]

Re: [VHFcontesting] FT-991 for FM contesting

To: nosigma@aol.com
Subject: Re: [VHFcontesting] FT-991 for FM contesting
From: Jeff Townsend <wb8lyj@gmail.com>
Date: Wed, 26 Feb 2020 08:53:41 -0500
List-post: <mailto:vhfcontesting@contesting.com>
I checked my 991A,
I do hear the signal at 147.456 but it is not very strong. It is only partial 
quieting.


> On Feb 26, 2020, at 8:08 AM, John Young via VHFcontesting 
> <vhfcontesting@contesting.com> wrote:
> 
> 
> Alan
> I use an FT991A and have not had the problems described. 
> 
> I usually run the squelch at zero and put up with the noise when in the 
> national radio quiet zone (with permission) and I run it at 2 when closer to 
> the DC area and near cell towers at my Freezeland road site.  I do this to 
> copy signals fluttering in and out of capture.
> 
> No noise bursts.  I will check 147.456 when I get home.  Lots of digital 
> garbage in the DC area on all bands, really bad when I set up the beam and 
> point to the CIA a few miles away.  LOL.
> 
> Send a copy of the video to Nosigma@aol.com
> I will give it a listen/look.
> 
> I love my 991A, it's been trouble free and with 12ft  beams and brick amps I 
> can reliably work 35W 2m/70cm stations on omnis out to 180 miles and big 
> stations on beams out to 300 miles from either of my hilltop sites.  6m FM is 
> the weakest band (I assume because the antenna gain is lowest of the 4 bands) 
> with the best being 220 via a Demi xvrtr with a 10m IF.
> 
> 73
> John
> KM4KMU 
> 
> 
> 
> On Wednesday, February 26, 2020 Alan Larson <wa6azp@gmail.com> wrote:
>   Has anyone used the FT-991 for FM contesting, particularly on 2 meters?
> I have been seeing some annoying behavior with it.
> 
>   The squelch has an initial setting of 5, which quiets the receiver on 28,
> 50, and 430 MHz bands.  On 144 MHz, there are bursts of noise as the
> squelch opens for a fraction of a second every 10-20 seconds, the interval
> varies a lot.  This is seen with a dummy load connected to the antenna
> connector, so it is not signals being received.
> 
>   I sent the rig to Yaesu for repair, and they reported that no problem was
> found, that I should just turn the squelch up higher.  Settings or 15 to 20
> seem necessary on 144 MHz to minimize the noise bursts.  Since my goal
> would be to hear the weak signals, I don't want to turn the squelch up
> higher than necessary.
> 
>   Also, I have found various birdies in the receiver on VHF bands, a
> particularly strong one was near 147.456, which could be received on a
> second receiver near the 991.
> 
>   Do others see similar issues?  This radio is fairly early, so it would be
> interesting to know if the FT-991a has similar problems.
> 
>   I have a video of some of this, if any are interested, I will look at
> reducing the size and mailing a copy.
> 
>   Thanks,
> 
>         Alan
> _______________________________________________
> VHFcontesting mailing list
> VHFcontesting@contesting.com
> http://lists.contesting.com/mailman/listinfo/vhfcontesting
> _______________________________________________
> VHFcontesting mailing list
> VHFcontesting@contesting.com
> http://lists.contesting.com/mailman/listinfo/vhfcontesting

_______________________________________________
VHFcontesting mailing list
VHFcontesting@contesting.com
http://lists.contesting.com/mailman/listinfo/vhfcontesting

<Prev in Thread] Current Thread [Next in Thread>