I've been using a homebrew transverter. For years I've been using a
"no-tune" design by W1VT. I etched the boards myself. I built a GaAsFET
preamp and got a power module that puts out 10 watts. I'm currently working
on building the W1GHZ 222 design, which is a lot smaller.
73, Zack W9SZ
On Thu, Sep 8, 2022 at 11:25 AM Howard Reynolds <wa3eoq@gmail.com> wrote:
> Up until a year or so ago I ran an FT736R with a 100W brick. Antenna has
> always been 16 elements up 80 feet with antenna mounted preamp. (The 736R
> was still working fine, but some critical parts were becoming unavailable
> if they failed.) I have now upgraded the station with an IC-9700 for 144,
> 432, and 1296 so now I needed to go back to a transverter for 222MHz. For
> that band I now use a K3s for an IF driving a Q5 Signal (nee DEMI) 100W
> transverter. The 100W gets me around just fine and, with the preamp, I
> hear very well. I also have 1-5/8 inch hard line to the antenna, so most
> of the 100W gets there. 222MHz is VHF Ham Radio's best kept secret, many
> times out-performing 2m. No need to run a kW. See you there. WA3EOQ
> _______________________________________________
> VHFcontesting mailing list
> VHFcontesting@contesting.com
> http://lists.contesting.com/mailman/listinfo/vhfcontesting
>
_______________________________________________
VHFcontesting mailing list
VHFcontesting@contesting.com
http://lists.contesting.com/mailman/listinfo/vhfcontesting
|