Hi,
These are for a KWTS440, but probably the same.
1 NC
2 NC
3 Data OutPut 300 mV or more at maximum recieving input with a 4.7K load
4 GND Connect shield of audio here
5 NC
6 NC
7 NC
8 gnd
9 Mic Mute Signal input of Mic jack is grounded if you pull this to gnd
10 NC
11 Data Input Input Terminalfor data comunications. In SSB Mic Gain can be
controlled by the MIC Control. 500 MV or Less
12 GND
13 Standby Standby Terminal - Grounding transmits
Good Luck
Phil
KF8JW
PS - Last month a slew of ACC2 stuff ran on the reflector - check the
archives at contesting.com
--
WWW: http://www.contesting.com/writelog
Submissions: writelog@contesting.com
Administrative requests: writelog-REQUEST@contesting.com
Problems: owner-writelog@contesting.com
|