WriteLog
[Top] [All Lists]

[WriteLog] FT-920 polling problem

To: <writelog@contesting.com>
Subject: [WriteLog] FT-920 polling problem
From: Rick.Commo@verizon.net (Rick Commo)
Date: Sun, 9 Dec 2001 18:33:11 -0800
Barry,
Good point - thanks!  I have been confused by this in the past, but not in
relation to WL.

-rick


-----Original Message-----
From: writelog-admin@contesting.com
[mailto:writelog-admin@contesting.com]On Behalf Of Barry N1EU
Sent: Sunday, December 09, 2001 3:24 PM
To: Rick.Commo@verizon.net; writelog@contesting.com
Subject: RE: [WriteLog] FT-920 polling problem


Rick, make sure the FT-920 is in "VFO" mode and not "MEM" or "MEM TUNE" (at
least that's what the modes are called in the MP).  WL will not read the
freq otherwise.  Hit the M --> A button to transfer the 920 into vfo mode if
necessary.

73,
Barry  N1EU

>From: "Rick Commo" <Rick.Commo@verizon.net>
>Reply-To: <Rick.Commo@verizon.net>
>To: "Writelog" <writelog@contesting.com>
>CC: <w4atl@arrl.net>
>Subject: RE: [WriteLog] FT-920 polling problem
To: <writelog@contesting.com>
>Date: Sun, 9 Dec 2001 15:04:14 -0800
>
>Think I might have found part of the problem.  What it boils down to is
>this:
>
>(1) Using the dial or band switch and WL keeps up
>(2) Use the rig's number pad to punch in a frequency and WL keeps up.
>(3) Use the QMB (Quick Memory Bank) switch to jump back to previously saved
>old frequency and there is disconnect between WL and the rig.  WL is
>polling
>the rig, (CAT indicator flashes) but never updates the screen.
>
>So I presume that there is some sort of problem communications problem at
>that point that keeps WL "blind" as to the rig's real freq.  There is a
>work
>around so I am not going to worry about it at this point.
>

_________________________________________________________________
Get your FREE download of MSN Explorer at http://explorer.msn.com/intl.asp

_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog


<Prev in Thread] Current Thread [Next in Thread>