I am having a similar problem with my FT-1000D and Rigblaster Plus.
WL won't seem to keep my FT-1000D port selection selection - it keeps reverting
to the TenTec setting. I haven't figured it out either yet.
Craig
>
> From: "N5PA" <n5pa@comcast.net>
> Date: 2003/12/01 Mon AM 10:48:38 EST
> To: <writelog@contesting.com>
> Subject: [WriteLog] Saving Port Configuration
>
> I used my RigBlaster Pro to work the contest this weekend because I could
> not get my W5XD Multi-Keyer to work with my Yaesu FT-1000MP Mark-V. I use
> rig control on COM1 and have my RigBlaster Pro on COM4, with CW checked.
> When I bring up WriteLog it keys the rig up with a carrier on CW until I
> bring up the Port Setup screen and change the rig on COM4 from Ten-Tec
> Omni-V to Yaesu FT-1KMP and click OK. After that the CW works fine. After
> that I go into SETUP and SAVE CONFIGURATION to save the options and then go
> to FILE and SAVE. When I close WriteLog and bring it back up it has
> reverted back to Ten-Tec Omni-V on COM4. Any help with this or getting my
> W5XD box going would be appreciated. Had the same problem with the W5XD
> box, it would never save the Port Setup.
>
> Alan, N5PA
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web: http://www.writelog.com/
>
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|