I'm new to WriteLog and trying to set it up on my PC. I have 3 COM Ports, one
native, two on a PCI card. COM1 is alrealy host to a fussy device who's driver
loses it on other COM ports, so I'm left with WriteLog on another port.
When I go into Setup and select COM2 and all, WriteLog will see the radio (Icom
IC-706MkIIg) for a minute, and then lose it (No Rig!). When I experimentally
switched it over to the COM1 port, all seemed well for the few minutes I tested
it.
I'm wondering if anybody's seen a problem like this (I see all sort of success
stories in the archives), and whether it's been fixed.
Thanks in advance,
John Griswold, KB1HDO
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|