For SO2R, as I shuffle back and forth between two sound cards (RTTY w/MMTTY
plug-ins) and one sound card (decoding CW), I've found that I have to set
some of the sound card settings without WriteLog running. Then everything
works fine.
Chuck, KE4OAR
----- Original Message -----
From: "Larry L Lindblom" <llindblom@juno.com>
To: <dalej@reboot.bc.ca>
Cc: <writelog@contesting.com>
Sent: Saturday, January 17, 2004 11:08 AM
Subject: Re: [WriteLog] Writelog V/S sound card
> I'd been running MMTTY in AFSK mode and had rock stead sound levels.
> But, when I tried it in FSK mode I had the same problem you described.
> Finally out of desperation I renamed my Writelog.ini file and did an
> install of my most recent full Writelog version I have (10.44B) along
> with the MMTTY plug in, etc. This of course required some work to get the
> new ini file updated with all my rig, ports, and other information.
>
> I tested the new install and ini file by playing around in RTTY RU for 15
> or so hours. Lo and behold the sound level with MMTTY in FSK mode was
> rock solid. Why a setting in the ini file would have cause the problem
> is beyond , but all I know is that what I did resolved the problem. Oh,
> before that I'd tried a reinstall with my old ini file in place but the
> problem persisted.
>
> 73 & GL
> Larry L W0ETC
>
>
> On Sat, 17 Jan 2004 01:10:44 -0800 Dale Jackaman <dalej@reboot.bc.ca>
> writes:
> > I'm also now having a problem with my sound card which I haven't seen
> >
> > before, latest build of Writelog 10.44B but the earlier build was
> > also
> > doing this. Worked for months on this machine but it's now a major
> >
> > problem. I did a clean re-install of XP and installed Writelog but
> > no
> > change.
> >
> > While running MMTY (or native RTTY in Writelog) the sound input
> > keeps
> > bouncing between overflow and very weak and does this mode switching
> > after
> > a RTTY transmission. Does this on both Mic and Line-In inputs. The
> > audio
> > input slider controls can be put to zero and MMTY is still in an
> > overflow
> > condition. Mute is all that works. Transmitting RTTY on and off a
> > few
> > times kicks it into a lower audio input mode that works for perhaps
> > two or
> > three transmissions but soon goes back into overflow again. Not an
> > RFI
> > issue as it does this with zero power output. Not a radio problem
> > as
> > sampling the audio output from the 756Pro shows a steady audio
> > output. Not
> > the computer because it doesn't exhibit this behavior outside of
> > Writelog.
> >
> >
> > I'm stumped. Any ideas?
> >
> > Dale VE7GL
> > ve7gl@rac.ca
> > http://ve7gl.reboot.bc.ca
> >
> > _______________________________________________
> > WriteLog mailing list
> > WriteLog@contesting.com
> > http://lists.contesting.com/mailman/listinfo/writelog
> > WriteLog on the web: http://www.writelog.com/
> >
> >
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web: http://www.writelog.com/
>
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|