The problem I was having on RTTY, was after transmitting and going back
to receive the receive level varied greatly - from over driven to too low
to decode. The full reinstall with a new INI file resolve that for me.
73 W0ETC
On Sat, 17 Jan 2004 12:50:09 -0500 "Chuck Fullgraf"
<cfullgraf@sprynet.com> writes:
> For SO2R, as I shuffle back and forth between two sound cards (RTTY
> w/MMTTY
> plug-ins) and one sound card (decoding CW), I've found that I have
> to set
> some of the sound card settings without WriteLog running. Then
> everything
> works fine.
>
> Chuck, KE4OAR
>
> ----- Original Message -----
> From: "Larry L Lindblom" <llindblom@juno.com>
> To: <dalej@reboot.bc.ca>
> Cc: <writelog@contesting.com>
> Sent: Saturday, January 17, 2004 11:08 AM
> Subject: Re: [WriteLog] Writelog V/S sound card
>
>
> > I'd been running MMTTY in AFSK mode and had rock stead sound
> levels.
> > But, when I tried it in FSK mode I had the same problem you
> described.
> > Finally out of desperation I renamed my Writelog.ini file and did
> an
> > install of my most recent full Writelog version I have (10.44B)
> along
> > with the MMTTY plug in, etc. This of course required some work to
> get the
> > new ini file updated with all my rig, ports, and other
> information.
> >
> > I tested the new install and ini file by playing around in RTTY RU
> for 15
> > or so hours. Lo and behold the sound level with MMTTY in FSK mode
> was
> > rock solid. Why a setting in the ini file would have cause the
> problem
> > is beyond , but all I know is that what I did resolved the
> problem. Oh,
> > before that I'd tried a reinstall with my old ini file in place
> but the
> > problem persisted.
> >
> > 73 & GL
> > Larry L W0ETC
> >
> >
> > On Sat, 17 Jan 2004 01:10:44 -0800 Dale Jackaman
> <dalej@reboot.bc.ca>
> > writes:
> > > I'm also now having a problem with my sound card which I haven't
> seen
> > >
> > > before, latest build of Writelog 10.44B but the earlier build
> was
> > > also
> > > doing this. Worked for months on this machine but it's now a
> major
> > >
> > > problem. I did a clean re-install of XP and installed Writelog
> but
> > > no
> > > change.
> > >
> > > While running MMTY (or native RTTY in Writelog) the sound input
> > > keeps
> > > bouncing between overflow and very weak and does this mode
> switching
> > > after
> > > a RTTY transmission. Does this on both Mic and Line-In inputs.
> The
> > > audio
> > > input slider controls can be put to zero and MMTY is still in
> an
> > > overflow
> > > condition. Mute is all that works. Transmitting RTTY on and
> off a
> > > few
> > > times kicks it into a lower audio input mode that works for
> perhaps
> > > two or
> > > three transmissions but soon goes back into overflow again. Not
> an
> > > RFI
> > > issue as it does this with zero power output. Not a radio
> problem
> > > as
> > > sampling the audio output from the 756Pro shows a steady audio
> > > output. Not
> > > the computer because it doesn't exhibit this behavior outside
> of
> > > Writelog.
> > >
> > >
> > > I'm stumped. Any ideas?
> > >
> > > Dale VE7GL
> > > ve7gl@rac.ca
> > > http://ve7gl.reboot.bc.ca
> > >
> > > _______________________________________________
> > > WriteLog mailing list
> > > WriteLog@contesting.com
> > > http://lists.contesting.com/mailman/listinfo/writelog
> > > WriteLog on the web: http://www.writelog.com/
> > >
> > >
> > _______________________________________________
> > WriteLog mailing list
> > WriteLog@contesting.com
> > http://lists.contesting.com/mailman/listinfo/writelog
> > WriteLog on the web: http://www.writelog.com/
> >
>
>
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web: http://www.writelog.com/
>
>
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|