I've spent a couple of hours messing around, and made 59 qsos in the BARTG
contest with Writelog, MMTTY, my ProII @100w and a G5RV laying on my roof. Not
bad.
So far, everything seems to work fine, except that I think my Rigblaster has
failed since my afsk tones do not pass through it. I'm not sure why. I think
the PTT may not be pulling in. How am I supposed to configure for the PTT on
the serial port for the rigblaster? My LPT port PTT is working though - go
figure.
I may toss the Rigblaster and just make my own to clear up this mystery.
I have one complaint, and one bug report.
The complaint is regarding the scrolling of the rttyrite screen. How do I make
it stop doing what ever it does where when it fills up the screen, it goes back
up to the top. I don't know where to look. New text should always appear at
the bottom, and then the old text should just scroll up.
The bug report is that I tried to do a timed CQ, and Writelog/MMTTY went nuts.
It started sending my CQ message over and over. I stopped it, and after that,
the memories would not send their contents properly. I shut all the programs,
rebooted the computer, and have not tried a timed CQ again.
RTTY's cool.
73,
Bob N5NJ
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|